HP LASERJET RESOURCES

50 Error

Check Side Connector

HP LaserJet fusing assemblies that use flexible sleeves give 50 errors if a squeeze-on clip to the heating element is out of place. If the clip is pressed during shipping or handling, the connector can slide partway off, breaking the connection to the heating element, which heats the fuser, or to the thermistor, which detects fuser heat. Either way, the result is a 50 error.

When you get a 50 error after installing a fuser of this type, check the connectors before returning the fuser as defective. If a connector has come off, it is a simple matter of sliding it back on.

connector

50 Error

Check Side Connector

HP LaserJet fusing assemblies that use flexible sleeves give 50 errors if a squeeze-on clip to the heating element is out of place. If the clip is pressed during shipping or handling, the connector can slide partway off, breaking the connection to the heating element, which heats the fuser, or to the thermistor, which detects fuser heat. Either way, the result is a 50 error.

When you get a 50 error after installing a fuser of this type, check the connectors before returning the fuser as defective. If a connector has come off, it is a simple matter of sliding it back on.

connector

50 Error

Check Side Connector

HP LaserJet fusing assemblies that use flexible sleeves give 50 errors if a squeeze-on clip to the heating element is out of place. If the clip is pressed during shipping or handling, the connector can slide partway off, breaking the connection to the heating element, which heats the fuser, or to the thermistor, which detects fuser heat. Either way, the result is a 50 error.

When you get a 50 error after installing a fuser of this type, check the connectors before returning the fuser as defective. If a connector has come off, it is a simple matter of sliding it back on.

connector